Emergency maintenance and handling methods for driving faults:

1.进、出水软管破裂

1. The inlet and outlet hoses are broken

破裂不大时，可用涂有一层肥皂的布将漏水处包扎好；如破裂较大时，可将软管破裂处切断，在中间套上一个竹管或铁管，并用铁丝捆紧。

When the rupture is not significant, a cloth coated with a layer of soap can be used to wrap up the leaking area; If the rupture is significant, the hose can be cut off at the point of rupture, and a bamboo or iron pipe can be placed in the middle and tied tightly with iron wire.

2.风扇皮带断裂

2. Fan belt broken

可把断了的皮带用铁丝扎好或采用开开停停的办法把车开走。

You can tie the broken belt with wire or use a stop and start method to drive the car away.

3.螺孔滑扣

3. Screw hole sliding buckle

螺孔滑扣会导致漏油或连杆松动，使其无法工作。这时可将原螺杆用锤子砸扁，使其两边膨胀增大再紧固好，但不可多次拆卸，待下次保养时修理。

Screw hole sliding buckle can cause oil leakage or loosening of the connecting rod, making it unable to work. At this point, the original screw can be flattened with a hammer to increase its expansion on both sides and then tightened, but it cannot be disassembled multiple times and will be repaired during the next maintenance.

4.油箱损伤

4. Fuel tank damage

机动车在使用时，发现油箱漏油，可将漏油处擦干净，用肥皂或泡泡糖涂在漏油处，暂时堵塞；用环氧树脂胶粘剂修补，效果好。

When a motor vehicle is in use and finds oil leakage in the fuel tank, it can be wiped clean and coated with soap or bubble gum to temporarily block the oil leakage; Repairing with epoxy resin adhesive yields good results.

5.油管破裂

5. Oil pipe rupture

油管破裂时可将破裂处擦干净，涂上肥皂，用布条或胶布缠绕在油管破裂处，并用铁丝捆紧，然后再涂上一层肥皂。

When the oil pipe ruptures, the ruptured area can be wiped clean, coated with soap, wrapped with cloth or tape around the ruptured area, tied tightly with iron wire, and then coated with a layer of soap.

6.油管折断

6. Oil pipe breakage

油管折断时可找根与油管直径相适应的胶皮或塑料管套接。如套接不够紧密，两端再用铁丝捆紧防止漏油。

When the oil pipe is broken, a rubber or plastic pipe that is suitable for the diameter of the oil pipe can be used to connect it. If the fitting is not tight enough, tie both ends tightly with iron wire to prevent oil leakage.

7.缸盖出现漏洞而漏油、漏水

7. Leakage of oil and water due to cylinder head leakage

可根据漏洞大小，选用相应规格的电工用保险丝，用手锤轻轻将其砸入漏洞内，即可漏油、漏水。

According to the size of the vulnerability, appropriate specifications of electrician fuses can be selected, and gently smashed into the vulnerability with a hammer to eliminate oil and water leakage.