Love car travel, will inevitably go wrong, especially in the event of an emergency when the car suddenly caught fire, a series of attempts have not responded, only to find that the original battery was not caused by electricity, it is about to delay major events, what should we do in the end? Don't worry, today Xiaobian is for your rescue, remember the following points, you don't have to worry about the car is out of power.

　　一、推车启动

　　I. Launching of carts

　　这是一种不得己的手腕，不能经常运用，这个需求察看车辆所在的位置，假如是下坡能够借此进步车速，假如是上坡这种办法使不得，车速也很难进步，应该调转车头向下坡方向推车。尽量不要在车辆和行人多的路段推车起动，以免车辆起动后驾驶者应变不当呈现不测。

　　This is a kind of unavoidable wrist, which can not be used frequently. This demand inspects the location of the vehicle. If downhill can improve the speed of the vehicle by this way, if uphill is unavoidable, the speed of the vehicle is also difficult to improve. We should turn the head to push the vehicle downhill. As far as possible, don't start the cart in the section with many vehicles and pedestrians, in order to avoid the driver's inappropriate response after the vehicle starts.

　　车辆推进之前应翻开点火开关，到达相当车速后，将变速器挂入挡位，然后疾速松开离合器踏板并加油。引擎一旦起动，应疾速踩下离合器踏板，样做对发起机和离合器有一定的损伤，自动挡车辆特别要防止运用此办法起动。推车起动普通需求两个人以上，假如只要司机一人就难以施行起动同时控制油门，不让发起机熄火，然后渐渐停车。

　　The ignition switch should be turned on before the vehicle is propelled. After reaching a comparable speed, the transmission should be put in gear, and then the clutch pedal should be quickly loosened and refueled. Once the engine is started, the clutch pedal should be stepped down quickly, which will cause some damage to the generator and clutch. In particular, auto-stop vehicles should be prevented from starting by this method. The ordinary demand for starting a cart is more than two people. If only one driver can't start and control the throttle at the same time, don't let the engine stall, and then stop gradually.

　　二、搭接启动

　　2. Overlap Start

　　假如遇到状况时还有同行的车，车上还有跨接电缆时，还能够采用电瓶搭接的办法启动车辆。详细操作时先将两辆车靠近，直到跨接电缆足够衔接两块蓄电池的正负极。要留意确保两辆车没有接触，只允许运用具有足够的承载才能且带绝缘外皮的电缆。假如提供电源的蓄电池在车辆上的装置位置不便当直接停止跨接，则必需运用工具将蓄电池拆下。

　　If there is a peer car in case of a situation, and when there is a straddle cable on the car, the battery lapping method can also be used to start the vehicle. Detailed operation will be carried out by approaching the two vehicles until the cross cable is sufficient to connect the positive and negative electrodes of the two batteries. Care should be taken to ensure that the two vehicles are not in contact and that only cable with sufficient carrying capacity and insulated skin is allowed to be used. If the position of the battery on the vehicle is inconvenient, the battery must be removed by means of tools.

　　关闭车上一切隶属用电设备，启动提供电源的蓄电池所在的车辆，使其发起机运转几分钟以保证电量充足。然后按正常方式起动无电车辆，起动后应轻踩加速踏板，使发起机以2000r/min的转速运转几分钟。然后关闭两辆车的点火开

　　Turn off all subordinate electrical equipment on the vehicle and start the vehicle where the batteries provide power. Make the starter run for a few minutes to ensure sufficient power. Then start the non-electric vehicle in the normal way. After starting, the accelerator pedal should be slightly pressed to make the engine run at the speed of 2000 r/min for several minutes. Then turn off the ignition of the two cars and turn on

　　关，当心撤除电缆，留意防止正负极电缆接头相碰。

　　Close, take care to remove the cable, pay attention to prevent the cathode and cathode cable joint collision.

　　温馨提示：汽车没电再放一会也不会有电,而且电量只会越来越少;万一车彻底没电了，您好还是呼叫救援，让修理厂的人过来拖车吧！

　　Warm Tip: The car will not be able to run without electricity for a while, and the electricity will only be less and less; in case the car is completely out of power, you'd better call for rescue and let the repairman come over to the trailer bar!